This is for the RecRoomMasters Xtension Sit Down Pedestal.

The attachment part is about 20.5mm/.8 inches so it could work on more setups. Even this one should use a little tape or hot glue to really make it 100% secure.

I wanted a decent cup holder for my setup and this works nicely.

There are a couple different versions - single print / split print / round / round with hole / square.

The round one holds a beer bottler, cans and more.

There is a large hole in the bottom that will let things spill out instead of getting all nasty inside.

The square version (not picture) can hold, well, a lot of different things.

I have a single round version you can print, but depending on your printer, you may have issues with supports or overhang angles.

This is why I split the model and made the slide in attachment part separate that you can then glue to the holder part.

The slide in area that attaches to the arcade stand is about 20.5mm/.8 inches - and it leaves some room that you should thicken up with either tape or hot glue(inside the part - NOT hot-gluing to the arcade itself). Test things out so it fits snugly. I used hot glue to add a little more thickness and ‘stickiness’ and so far, about 6 months in, it is surviving a 6 year old boy.

I printed a bunch in different colors to add some more fun to the arcade and I have changed them a few times to keep it fresh.

You may want to print the attacher part with a brim to prevent any print failures or warping/lifting depending on your setup.