These will print so much easier using an AMS and Bambu Studio or Orca for the color changes (originally used Cura on an Ender 3)…

(NOTE ON PICTURE: I ran out of red PLA so I could not reprint this - but I will need to adjust the speed and line width since there are some gaps here and there - its just slicer issue - not the model!)

I wanted a simple and small ‘GAME OVER’ sign for my gaming area, but wanted a 3 color sign that didn't require much work while printing.

This has three tiers that you can use your slicer to add layer changes at. You can change once or twice… its up to you. :)

Its just 150mm x 80mm x 5.5mm high… you can rescale in your slicer as desired.

I printed mine using:

.28 layer height / .52 line width / 90mm/s (Klipper) / print time just under 1 hour / ~40g

Used Polymaker Matte PLA colors for the print.

You can re-Tinker it here: tinkercad.com/things/5tsMZykJbk6-game-over-3-color