The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:

PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA PolyLite Grey Transmission Distance: 1
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #10 (0.88mm) swap to Grey
At layer #16 (1.36mm) swap to Jade White
At layer #17 (1.44mm) swap to Red for the rest.