A storage and travel case intended for my Lee Valley Veritas Micro-Adjust Wheel Marking Gauge. This case was designed to provide an added layer of protection during a woodworking class where breaks and a community classroom made it necessary to have a flexible dividers. By moving these dividers to different slots it's possible to store virtually any measurements safely, or for the case to act as a stand preventing the marking gauge from rolling off a workbench.

The retainers, which slide over the marking gauge from above, were added as an extra layer of protection since I frequently store the case vertically in a tool backpack.

My print profile has resulted in a functional case several times using PLA, but typically result in a small amount of cosmetic warp that can be seen in the photos. If you have better results with different settings, make sure to share your print profile for others to use as well.