Modular Trade Show Display Stand

A great display stand for adding height to your trade booth.

Features:

• 3 tier design.
• Modular with joining segments, so you can add as many tiered sections as needed.
• Uses minimal filament.
• You can print 2 stands on 1 A1 Mini build plate.
• No support required.
• A simple and effective way to showcase mini animals, keychains and fidget toys
• Each tier is 40mm high.
• Each shelf is 48mm deep x 160mm wide and includes a 2mm ledge to stop models falling off.
• A strong and sturdy solution that can be used time and time again.

Assembly Of Multiples:

• Insert each ‘Joiner’ so that they butt up to the internal stop
• Add a spot of super glue to hold the joiners in place.
• Slide the next tiered section over the joiners.

Extra Info:

The included print profile is set up with 1 tiered stand and 1 set of joiners.

You can fit 2 full stands on one A1 Mini build plate by cloning and rotating into position.

The stands are designed to be printed with only 1 wall and minimal infill.

When re arranging you need to make sure that the side of the stand with the internal ledge is at the top, as there is a chamfer on one side of this to allow for support free printing.

Glue only needs to be applied to the stand that will permanently have the modular joiners in place. As then they will simply pull apart for easy pack down and transportation.

Thanks for looking!

Please rate and review your printing experience :)