I have been looking for a while now for a riser for my monitor for my desk. I have my laptop and dual monitors, laptop is on a stand which raises the screen up higher, middle monitor is a 32 inch TV, until now has been stood on top of 2 stacks of 2 empty filament spools, and then a monitor on the left turned landscape.

I have seen a few designs from other people that incorporate drawers into their design, but use a lot of filament for printing, so i decided finally to design my own on Fusion360.

The design I came up with for the width of the stand on my monitor can either used 2 sets of drawers or 3, each set of drawers uses 388g of filament.

This is the first iteration of the design, so as of now there is no way to connect the sets of drawers together, I am only using 2 at the moment, with a gap in the middle, second on is currently printing so will be setup under my monitor when it is done.

All printed in PLA on the Elegoo Neptune 3 Pro with 20% infill, also you will need to rotate the shell 90 degrees so it prints on its back.