SCROG net holder designed for 22 mm grow tent poles like on AC Infinity tents. Holds two pieces of SCH 40 ½" PVC pipe at a 90 degree angle. 

Printed in ABS with no supports & 20% infill and holds very strong. Should print well in PETG also. 

Inspired by 3DJunkPile's model but redesigned from scratch in Fusion. You can find their version here: https://www.printables.com/model/244929-16mm-or-19mm-tent-pole-to-22mm-pvc-holder-for-scro


Updated 6/14/24:

Version 2: Much stronger than v1. Thicker walls with sharp 90 degree corners removed. Prints at 45 degrees so the layer lines don't run parallel to either the PVC pipe or the tent pole for extra strength. Print with 3-6 walls and 15-20% infill. No supports, the model has supports included.

If you have trouble with the included supports not connecting when slicing set Slicing gap closing radius to 0.2 from the default of 0.049. 

Not connected (Slicing gap closing radius: 0.049):



Connected (Slicing gap closing radius: 0.2): 
 

In Bambu Studio or OrcaSlicer this setting is under Quality > Precision > Slice gap closing radius



In PrusaSlicer this setting is under Print Settings > Advanced > Slicing > Slice gap closing radius