Rotating organizer for office accessories or anything you need.

Dimensions:

• Total height with base: 121.5 mm
• Height without base: 112 mm
• Outer diameter: 126 mm
• Depths of subsequent compartments: 50 mm, 80 mm, 110 mm

You need:

• bearing dimensions 32mm x 20mm x 7mm
• silicone feet (bumps), diameter 10mm

The organizer was designed to be rotatable, but if you don't have a bearing, you can just print the organizer without a base and use it as a non-rotatable one.

The plastic shrinks when it cools down, so inserting the bearing may be difficult or, conversely, the bearing may be loose. I cannot predict how your filament will behave after it cools down, please take this into account when assessing the print. If it is tight, use force to drive the bearing in, and if it is loose, extend something, e.g. tape, paper or something else.