This is a MagSafe phone mount for the Dashboard circle on the Hyundai Elantra N. The file must be printed in PETG or ASA to prevent warping and UV damage when sitting in your hot car. 

You should print with at minimum 6 perimeters and 4 top and bottom solid layers- though the more the better - and at least 30% infill. 

The added walls and layers help prevent warping from heat. Smaller layer sizes like 0.16mm are preferred. Do not use supports. 

Caution: use my generated print file at your own risk. I have a custom printer profile that enables much faster start-up time, but you may be unaccustomed to it. There is also a 0.05mm offset on the first layer to account for textured plate squish, do not use my print file with a smooth or non-textured plate. My printed file is already painted for multi-color, but you may need to adjust the colors as your AMS will not match mine. 

You can use the AMS to achieve the multiple color “N” effect.

You need to add a ‘pause-at-height’ at the layer just prior to the bridging on the MagSafe area, and then add the magnets in once the print has paused. 

IMPORTANT: Ensure that you are orienting the magnets in the correct polarity. Before placing the magnets in the print, stick them to the MagSafe magnets on your phone, and see which orientation is proper. Whichever side “sticks” to your phone, place that side face down in the print. This will ensure that it is facing towards the front of the print once it is complete. 

MagSafe magnets from Amazon - https://a.co/d/0h5LaVPn

The backing supports up to 1" wide double-sided tape, and I prefer gel tape, as it is easy to remove once done.