Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
2.3 h
1 plate
0.2mm layer, 6 walls, 25% infill
2.8 h
1 plate
Boost
70
104
41
3
281
270
Released
Description
The model consists of two parts:
- shovel
- handle
It can be printed without supports if you orient it like shown in the picture.
The connection between the handle and the shovel is a tight fit. Optionally it can be glued in place with some ca- glue.
The cat inlay can be printed in a different color (2 layers on 0.2mm layerheight). Just load the models for the handle and the inlays together and set a different color for the inlays.
Comment & Rating (41)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
works great pieces fit together great quick print!
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
A little difficult to fit the two parts together (had to use a hammer) but the scoop works perfectly.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
saved me a trip to the store! printed perfectly and I ramped the layer height profile up to extra draft. printed in ~1 hour and works perfectly. thanks mate
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
This is amazing! Upscaled it to 150% and use it as a chicken poop scooper to clean under my roosting bars in our smaller coops. Works perfectly!
1
Reply
Scaled it to 150% and using it to scoop chicken poo from our coop. Works great!
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Really nice!!!
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
it clips very nice !
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
excellent w/o support
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
nice
1
Reply
Nice Design ! Thank you :)
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld