Project: Star wars Ahsoka.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
If changing size . . . only change X and Y, not Z.
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 2.3mm
Filaments Used:
PLA Creality Black Transmission Distance: 0.6
PLA Sunlu Blue Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Matte White Transmission Distance: 3.5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Blue
At layer #13 (1.12mm) swap to Gray
At layer #16 (1.36mm) swap to White
At layer #21 (1.76mm) swap to Gray
At layer #22 (1.84mm) swap to White for the rest.