iPad/iPhone charger mount
Copyright Claim
iPad/iPhone charger mount
Boost
7
11
5
Print Profile(2)
0.16mm layer, 2 walls, 10% infill
Designer
49 min
1 plate
easy to print
Designer
39 min
1 plate
Open in Bambu Studio
Boost
7
11
5
0
7
6
Released
Description
Its a organizer to put onto your iPad/iPhone charger to organize your charging cble while traveling.
I designed this to organize your charging essentials easely.
The supports are a bit difficult to remove but it takes no more than 5 minutes.
I printed in PLA.
(I used the charger of my iPad pro but should also fit for iPhone or other iPad chargers. If not please write a comment)
Comment & Rating (5)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
I change the standard support with tree support. is better for removing
(Edited)
The designer has replied
0
Reply
thanks, nice tipp
0
Reply
I printed the easy to print version, it was simple to remove the supports, no problems
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Support Issue:The model itself is nice, don’t get me wrong! But I if removing the supports takes as much time as printing… Phew. Could need some improvement 🙃
The designer has replied
0
Reply
thanks for your feedback, I uploadet a version which is easier to print. I hope I could help
(Edited)1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld