Skoda keychain fidget tag.
Model is optimized for multi material / multicolor print.
Spinning hinge is a short sections of filament.

After printing the rolling rings movement needs to be started by hand first. If you want a truly smooth movement use the provided holes to spray just a bit of WD40 between the faces and roll it a few times to spread it.

ASSEMBLY GUIDE:

• Cut a roughly 36.5 mm long section of filament to length.
• Align the the emblem by hand so the axis holes are in line.

• Push the cut filament section in from the top
• When you can't push it by hand use some filament as a push tool.
• Make sure that the fidgeting action works, roll and spin it a bit.
• If for some reason the fidget is as the axis is too long or broke use an exacto knife to cut filament segment, disassemble the emblem, use lines of filament to push out the discarded / broken lines of filament!

Printables link: https://www.printables.com/model/925141-skoda-keychain-fidget-2-degrees-of-freedom