Summary

This is a little object I made in my journey to master Blender. I hope you enjoy my first Thing! Please post this as a Make if you do print this. It really helps!

On my SVÄRTA bunk bed, I have been hanging blankets as protection from the sheer direct air blowing from the AC, and as a little privacy curtain. I used to just insert the thin blanket into the space between the frame and the mattress, but this eventually made the blanket fall.

To solve this, I made little clips to help secure blankets to the frame. Simple insert some of the blanket into the space between the frame and the mattress, and slip at least 3-4 of my SVÄRTA clips on spread out points across the blanket. It should be secure, and now the space at the bottom feels more cozy!

Important Notes!

• As said before, you need at least 3-4 of these clips to secure the blanket sheet.
• Only fits blankets with a width of 1.5-ish mm. If your blanket is too thin, consider folding it upon itself on the area where you will place the clips. If your blanket is too thick, well, pray that your PLA is strong enough :P
• Please slice and print it while it is laying down, as illustrated in one of the pictures.

Print Settings

Printer Brand: 

Creality

Printer:                      

Ender-3 V2 Neo

Rafts: 

No

Supports:                      

No

Resolution: 

0.28

Infill:                      

Cubic - 50%

Filament: Creality CR PLA
Any                    
                        

Notes:                     

You may choose to print 3 at a time. It worked for me at 50mm/s speed and 200 °C hot-end temperature.