Just a HueForge image of a wizard casting fireball. Image was AI generated with NightCafe.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA Anycubic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA Paramount 3D Black Cherry Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA Hatchbox True Red Transmission Distance: 4.5
PLA GeeeTech Orange Transmission Distance: 8
PLA Hatchbox True Yellow Transmission Distance: 6.8
This print uses 8 unique filaments

Swap Instructions:
Start with Black
At layer #9 (0.88mm) swap to Blue Gray
At layer #12 (1.2mm) swap to Gray
At layer #14 (1.28mm) swap to Black Cherry
At layer #15 (1.36mm) swap to Jade White
At layer #16 (1.44mm) swap to Red
At layer #19 (1.68mm) swap to Orange
At layer #22 (1.84mm) swap to Yellow for the rest.