Magic the Gathering Card Tray

Remixed by

Magic the Gathering Card Tray

Remixed by
Boost
1
2
3

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 10% infill, no support
0.2mm layer, 2 walls, 10% infill, no support
Designer
6.1 h
1 plate

Additional larger options on plate - same settings
Additional larger options on plate - same settings
Designer
14 h
2 plates

Open in Bambu Studio
Boost
1
2
3
0
1
1
Released

Description

A lot of my friends liked these and wanted to make them, but they ended up being too short, so i fixed it for them- and you!

CardStackEditedV3 stretched by 16mm is 127.67mm x 73.23mm x 97mm
CardStackEditedV3 streched by 18mm is 130mm x 73.88mm x 97mm
CardStackClosed streched by 11mm is 127.1mm x 72.27mm x 97mm
no levels card holder CLOSED is 72mm x 200mm x 96.988mm

Card Stack Closed streched extra long is 72.2mm x 153mm x 97mm

 

Comment & Rating (3)

Please fill in your opinion
(0/5000)

This is just great! However, it's still a bit too short for double sleeved cards. I'm not worried about it though because once you draw a hand and a turn or two the deck is just about flush. The red deck is single sleeved and the blue is double. Might be just perfect for a broken-in double sleeved deck. I printed the "solid" version. Because I wasn't sure if I wanted to risk it without support for the more "hollow" version. I also used Archimedean Chords for the top layer for a neat effect on what ends up being the back wall of the tray.
The designer has replied
0
Reply
Hi - yeah it fits most decks but some are still a little short - i am adding some slightly bigger ones as well if you want to try those when they are uploaded in a bit- also, the open sided one prints very well even without supports, it has some small drooping, but i normally just rip them off and it still looks great
0
Reply
Replying to @christianwagner :
note: i print them on its back, so ymmv if you do it other ways
0
Reply
No more