PLEASE NOTE: This lightbox design requires components from the Amity3D lightbox models, which I CANNOT legally provide you.

You can subscribe to Amity3D's Patreon to obtain printable models here:
https://www.patreon.com/Amity3D

Or you can purchase the lightbox assembly kit from his Etsy here:
https://www.etsy.com/listing/1600528417/lightbox-assembly-kit

In addition to the layers you'll print from this profile, you will need:
-One lightbox frame (printable from Amity3D, or sold in his kit)
-One lightbox back (printable from Amity3D, or sold in his kit)
-One 80mm x 195mm x 3mm plexiglass (sold in Amity3D kit, or your choice of plexi source. I buy from TAP Plastics).
-One LED kit (sold in Amity3D kit, or your choice. I buy from Amazon).

TAP Plastics: https://www.tapplastics.com/product/plastics/cut_to_size_plastic/acrylic_sheets_clear/508

Amazon LED light: https://www.amazon.com/gp/product/B0C5CB54JF

ASSEMBLY INSTRUCTIONS:
(1) Remove protective film from acrylic glass, insert into back of lightbox frame.
(2) Insert black layer with print surface facing glass.
(3) Insert blue layer behind black, then red layer, then transparent layer (the ultra thin white layer).

(4) Hold layers in place and flip box to confirm alignment. Return box to face-down position if correct.
(5) Hold layers down, hot glue in place on top of transparent layer. I usually only put a dab of hot glue in each of the four corners, then a dab in the middle.

(6) Remove adhesive backing from LED strip, then apply strip to the inside of the lightbox in just under 2 full loops. Trim excess. (NOTE: Amity3D sourced kits come pre-trimmed).

(7) Glue and attach back plate.

(8) Plug in and enjoy!

Assembly video: