Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Grey Transmission Distance: 1
PLA BambuLab Basic White Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Orange Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #14 (1.2mm) swap to Grey
At layer #21 (1.76mm) swap to White
At layer #23 (1.92mm) swap to Yellow
At layer #25 (2.08mm) swap to Orange for the rest.