Search models, users, collections, and posts
Spool Weight for Bambu AMS - Silica Mod
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 4 walls, 100% infill - PETG
Designer
2.7 h
1 plate
PLA 0.2mm layer, 4 walls, 100% infill
2.7 h
1 plate
Open in Bambu Studio
Boost
54
139
31
20
198
117
Released
Description
Spool Weight for Bambu AMS
Mod for use with silica gel
You can use it for spools with an inner diameter of ca. 55mm and width up to ca. 64mm
Layer height : 0,2 , line width : 0,4
Walls 4; top 1,0mm ; bottom 0,8mm
no support ; infill 100%
print time ~ 2h 58 min
Kingroon PETG Green -- you can also use PLA in AMS it doesn't get so warm !!
MakerWorld : https://makerworld.com/en/@sweb3791
My Models : https://www.printables.com/de/@CB_384764/models
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)