Stand to Hold Low Poly Pineapple by Print Ninja
Copyright Claim
Stand to Hold Low Poly Pineapple by Print Ninja
Boost
0
0
2
Print Profile(0)
Add the first print profile to earn points
Boost
0
0
2
0
2
0
Released
Description
Loved the Low Poly Pineapple by Print Ninja but needed it upside down for...reasons. IYKYK.
It's deliberately a loose fit to accommodate different printers tolerances. A few drops of gel CA in the pineapple, flip it over, and stick it in. They've been holding up as decorations at parties and for our friends. For the best quality print, use the STP. If you don't care, use the STL.
Original Low Poly Pineapple by Print Ninja is here:
https://makerworld.com/en/models/196936#profileId-335604
Comment & Rating (2)
All
Did you enlarge the pineapple to fit the stand? as when i printed the pineapple it is significantly smaller than the stand
The designer has replied
0
Reply
Nope I designed the stand to fit the pineapple I’m pretty sure. lol
It’s been a bit so I’ll check that and verify when I get home.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld