Pirate Chest by Cory Jorgensen

Cory Jorgensen

Miniatures>Other Miniatures

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 25% infill

Designer

3.3 h

1 plate

5.0(5)

Boost

101

Released

Description

If you like my work and would like to support me, please feel free to Buy Me a Coffee.

This is a simple little Treasure Chest.

I used 8mm x 2mm magnets on both the chest and lid. I place them opposite poles when I glue the magnets in so the lid will only fit one way.

You can find the magnets here: https://www.amazon.com/gp/product/B077KYBYYY/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

treasurechest

treasure

container

Comment & Rating (7)

@Servicebyedwin

Print Profile

0.2mm layer, 6 walls, 25% infill

Amazing print, even scaled up it looks great. if I had to change anything it’ll be the curve of the lid itself tends to come out a bit rough, maybe printer settings, but I can’t seem to find the sweet spot. And the lid itself only fits on properly in one direction, it’s not symmetrical the same when flipped around, so the bands on the chest only line up properly in one direction but not flipped 180 degrees. Though you wouldn’t even know if you just replace the lid normally. Great print Sir. The Image I’ve shared is at 150% scale for reference.

The designer has replied

@Derftoy

i noticed that about the print after a few prints. once I put the magnets in with reverse polarity it always only went on one way. I should look into the dimensions.

(Edited)