A small minimalist net cup that fits in 35mm holes. The cup is 45mm tall and has a outer lower diameter of 20mm and a upper outer diameter of 35mm with a little extra on the top to keep it from falling in. This net cup was designed to use as little filament as possible while still being able to serve its indented purpose.

This net cup can also be printed without any support when flipped 180 degrees in the slicer.

The print in the picture was made using the default settings for a 0.4mm nozzle for PLA with a few modifications. The infill was set to 100% and outer edge speed was taken down to 20. You can still print this net cup at full outer edge speed if you only care that it serves its purpose. However for prettier prints, I recommend you turn it down to 20. I also recommend to print 2 or more at a time so the filament has more time to harden in-between layers resulting in a improved overall print quality.