I'm working on a shadowbox of a few Carolina Hurricanes hueforge prints. Sharing them here as I go. This one is the 25 year anniversary logo. I'm printing these on an A1 with AMS. Unsure how they'll turn out utilizing other methods.

Project: Canes25Year.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x155.14mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

 

Filaments Used:
PLA HIGH SPEED 3DHojor Black Transmission Distance: 5
PLA HIGH SPEED 3DHojor Red Transmission Distance: 5
PLA HIGH SPEED 3DHojor Grey Transmission Distance: 5
PLA HIGH SPEED 3DHojor White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #16 (1.36mm) swap to Grey
At layer #21 (1.76mm) swap to White for the rest.