Bigger Bins!

I was in need of bigger bins for a variety of printers. To temporarily store or transport smaller printed items.

Take one of the Bigger Bins (Fuse, Form, Bambu Lab, or Blank) and connect it to its counter part the Bigger Bin - Other Half. These bins are easy to assemble without any fasteners. Glue could be added on the seem, but it is not required. I found that it is easiest to press the lip (short hooked side) in first before pressing in the other parts.

I needed a bracket with a groove, but I also added one without it.

The holes of the brackets are designed such that there is no support needed, but it has to be printed on its side for that. This also adds the most strength to the part for holding the Bigger Bins.

The hole sizes are for an ISO Countersunk Flat Head Screw (bolt) M6.

The Bigger Bins are stackable, even on the bracket.

Keep in mind these are large prints, so will take up quite a bit of filament, and my advice is to use glue on the buildplate to make sure the print remains in place until the print-job is finished.

Happy printing!