I needed a doorstop, so I printed a flex-style one that I liked. However, I forgot I had it and tried to close the door while in that doorstopper - as you can imagine, that broke my doorstop into a couple pieces and I had a doorstop no more.

That was when I knew I needed to design one that does not break when I close the door without stepping on it.

It is pretty minimalistic, you can use a vacuum around and on it (just make sure you are going through it from the glued side, does not require user action when opening or closing the door.

Use double sided tape on the thick part and stick it to the ground. Easy as that.

This is made for a door that is 10mm from the ground!

If you need it to be higher, either edit the model, or write a comment and I will do it for you.