I created a bumper and handle set to add a layer of protection to the aluminum sections of the Begode Falcon EUC. I will be offering these for sale, and will also allow the community to print my models themselves. It is important to note that these are not available for others to sell.

These are printed in TPU, with some parts requiring shims used during printing in lieu of supports that must be printed in PLA ahead of time. The printing process for the Front Bumpers - Screw Style and the Fin Protectors will involve these shims. You can try it with supports, but it can be a bit dicey trying to get the supports off nicely. Due to this, it's a good idea to print PLA shims that are inserted at pauses during the print to function as supports for the flat overhang sections. It helps to apply some gluestick adhesive to the top of the shims after installing them to help the first layer adhere better. My sliced files have the pauses ready to go, so I'd highly recommend using the Bambu Studio 3MF instead of just using the STL files to save you a lot of time. If using an X1 Carbon or an A1, be sure to adjust the retraction length to 1.5mm (up from the default 0.4mm for TPU profile) to avoid stringing between parts.

I did create an alternative Front Bumper - Zip Tie version of one part to help you avoid shims, though you would still need a shim for the Fin Protector part. If you decide to print that version of the Front Bumpers, you will just need small zip ties to attach them to the Falcon. There's a small recess for the head of the zip tie in the rear holes, allowing the head of the zip tie to slide into the the bumper for a close-to-flush fit. The standard bumpers will need two M3x12mm pan head screws and M3 nuts for installation.