This is a hueforge I made using an image of Sebastion Aho from the Carolina Hurricanes.
Project: Aho.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 150x150mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.1mm
Filaments Used:
PLA HIGH SPEED 3DHojor Black Transmission Distance: 5
PLA HIGH SPEED 3DHojor Red Transmission Distance: 5
PLA HIGH SPEED 3DHojor Grey Transmission Distance: 5
PLA HIGH SPEED 3DHojor White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #12 (1.04mm) swap to Grey
At layer #17 (1.44mm) swap to White for the rest.