Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:
Start with Blue
At layer #7 (0.64mm) swap to Ice Blue
At layer #12 (1.04mm) swap to Black
At layer #18 (1.52mm) swap to Gray
At layer #21 (1.76mm) swap to Blue Gray
At layer #24 (2mm) swap to Jade White for the rest.