Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Orange Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue Gray
At layer #8 (0.72mm) swap to Jade White
At layer #15 (1.28mm) swap to Black
At layer #20 (1.68mm) swap to Orange for the rest.