This holder is designed to keep three Wago 221-2411 securely held in place.

The wagos are tightly held in place via a snap fit gripping onto several features of the wagos.

You can just slide in the wagos from the side (see pictures). You should feel some resistance and get a snap sound when fully seated.

To remove any wagos again, i would recommend to put a wire into one end of the wago, closing the lever and then pulling the wire to the side and slightly up. Please note that this can take quite a bit of force. You shouldn't do this to often, as with every pull-out you run the risk of damaging some of the smaller features.

In the pictures you can see that the Bambu Labs Orange PLA fits quite nicely.

You can attach this mount via double sided tape. I would recommend 3M VHB.

The base plate measures 37x30 mm.

If anybody needs this mount for other arrangements (e.g. 2x) or with screw holes, just write me a comment!

Update (2024-06-21): increased wall thickness on the sides