Nice picture. I chose to run it thru Hueforge and this is what I came up with.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x296.97mm in size
You may print at higher layer heights below the Min Depth of 1.4mm
The Max Depth is 3.1mm and the Actual Depth is 2.6mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 8
PLA BambuLab Basic Orange Transmission Distance: 12
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #19 (1.6mm) swap to Red
At layer #23 (1.92mm) swap to Orange
At layer #26 (2.16mm) swap to Jade White for the rest.