Record crate made from 6 IKEA Kallax glass shelves and a few 3D printed parts.
What you need:
3D printed Parts:
- 4x Corner Bottom
- 2x Corner Top 1
- 2x Corner Top 2
- 1x Bottom Support
- (2x Inlay - if you want to combat the slippery glass floor)
Non 3D printed parts:
- 5 (or 6) x IKEA Kallax glass shelf
Easy to assemble, no screws or tools required. I recommend a little bit of sticky putty to keep everything together. All parts print without supports.
Assembly:
- Slide the glass shelves in the corner brackets
- Add the support block in the middle under the bottom (not sure if needed but better safe than sorry) and youre done. I did use 2 glass panels for the bottom but only for aestethics.