The initial project was to create it the same as the image but when I was making the changes/mixtures of the colors in the Hueforge program, I came up with this combination that I loved. I hope you like the redesign of the image and enjoy it.

Below I leave you the steps and the types of filaments, layers and others that I used in this project.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.52mm
The Max Depth is 2.3mm and the Actual Depth is 2.3mm

Filaments Used:
    GENERIC PLA - Basic Black Transmission Distance: 0.6
    GENERIC PLA - Basic Red Transmission Distance: 4
    GENERIC PLA - Sky Blue Transmission Distance: 2.6
    GENERIC PLA - Basic White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #4 (0.44mm) swap to Black
    At layer #5 (0.52mm) swap to Red
    At layer #9 (0.84mm) swap to Sky Blue
    At layer #14 (1.24mm) swap to White
    At layer #19 (1.64mm) swap to White for the rest.