TECH Hueforge. Couple of notes, you can do this all with a single AMS, just be sure to swap the filament colors within the AMS after it has printed. Example, once black has printed place the Red within it's slot, same goes for turquoise and light grey, and finally dark grey will be replaced with White.
If slicing yourself I highly recommend changing wall generation from classic to Archane. It will take forever to slice, but it will make the quality a bit better.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 142.83x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA Inland Turquoise Transmission Distance: 3.8
PLA 3Dhojor dark Grey Transmission Distance: 1
PLA BambuLab Basic Orange Transmission Distance: 5
PLA Sainsmart Rose Red Transmission Distance: 2
PLA Inland Light Grey Transmission Distance: 1
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 7 unique filaments
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Turquoise
At layer #11 (0.96mm) swap to Dark Grey
At layer #12 (1.04mm) swap to Orange
At layer #17 (1.44mm) swap to Rose Red
At layer #19 (1.6mm) swap to Light Grey
At layer #22 (1.84mm) swap to Jade White for the rest.