Harry Potter Deathly Hollows Holder for 1 Wand
Copyright Claim
Harry Potter Deathly Hollows Holder for 1 Wand
Boost
58
82
4
In Contest
Wizarding UniversePrint Profile(1)
Clip Connectors w/o Support 0.2mm layer, 3 walls, 15% infill
Designer
9.3 h
4 plates
Open in Bambu Studio
Boost
58
82
4
0
42
6
Released
Description
The Deathly Hollows symbol adapted to fit 1 wand (ideally the elder wand) in the middle.
The wands are not included and can either be purchased separately or be printed.
The center fits the official 40cm elder wand being sold by wizarding world.
Prints well at 0.2mm Layer height and with no supports as in the print profile. Its a click system with connectors.
I recommend printing the connectors in PETG for better handling during installation.
A even nicer model that holds 4 additional wands alongside the elder wand is found here: https://makerworld.com/en/models/419711#profileId-322394
Comment & Rating (4)
All
i printed this as a present and it came out great, the only thing that bothers me, that of u print like me at 50% schale it would be big enough to be printed in one piece. Maybe you can make a version in one piece.
The designer has replied
0
Reply
Thanks for the feedback and I see your point. But the whole idea of this model was that the original elder wand fits just inside it to complete the symbol without poking out on top so much. But I will think about it :)
0
Reply
It looks great! A pity that it is not possible to print on the A1 mini :(
0
Reply
thats why ne name MINI in there, but u can cut it by programs in half
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld