Bogg Bag Stanley Cup Holder by Joshua.loebenberg2

Joshua.loebenberg2

Fashion>Bags

In Contest

Beach & Pool Essentials

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 3 walls, 15% infill

Designer

12.2 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Designed this cup holder for my wife's obnoxiously huge Stanley 40oz cup so it's easily accessible and off the sand while at the beach. She wanted to make sure that the cup holder was also supported through one of the holes in the side of the bag. The screw and nut take a bit of work to get on because of the tolerance and Z-seam, but it works. I will adjust later with a remix if necessary. This also works on other drink cups too like our large (32 oz) Simply Modern cups and obviously anything smaller.

beach beverage holder

Comment & Rating (6)

@Bjall4Jc

Print Profile

0.12mm layer, 3 walls, 15% infill

good print.

(Edited)

The designer has replied

@Joshua.loebenbe

I’m so sorry that happened. I hope you give it another shot. I dried my filament before and it worked fine. perhaps try that. if not, I totally understand.

(Edited)

@Bjall4Jc

Replying to @Joshua.loebenbe :

I'm going to try again. Just not sure which filament to try. this was petg. maybe pla+? since it's for a bogg bag, I don't want it to warp/deform in a hot car.

(Edited)

@Joshua.loebenbe

Replying to @Bjall4Jc :

I did pla+ and it stood up to the beach and pool all weekend. I’ve also used matte PLA in my truck for my simply modern 32 oz bottle holder with barely any issues other than the bumps on the cup holder holding it in place. I live in Florida just for reference.

(Edited)