模型介绍

为酷态科6号充电宝设计的保护壳。

设计为3片式结构，拼装好后可以完全包裹住充电宝本体，防止划伤；壳体尖锐边缘均已作圆角处理；顶壳开孔用于充电线插入。

拼装步骤

首先将充电宝放入柱状壳内，随后从柱状壳缺口滑入入长条状壳，最后将顶壳卡入柱状壳顶部。

关于材料

柱状壳以及顶壳可以使用任意你喜欢的材料，长条壳建议使用透明材料打印，以观察剩余电量显示屏。

我使用PLA（polymaker）材料打印，效果良好。

Model Introduction

Protective Case for Cuktech 6 Power Bank

Designed with a 3-piece structure, the case fully encloses the power bank once assembled, preventing scratches. All sharp edges of the case have been rounded off. The top case has an opening for inserting the charging cable.

Assembly Steps

First, place the power bank into the cylindrical case. Then, slide the rectangular case into the slot of the cylindrical case. Finally, snap the top case into the top of the cylindrical case.

About the Materials

The cylindrical and top cases can be made from any material you prefer. It is recommended to use a transparent material for the rectangular case to monitor the remaining battery display.

I used PLA (Polymaker) material for printing, and the result was excellent.