Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 7 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #4 (0.64mm) swap to Blue Gray
At layer #5 (0.8mm) swap to Gray
At layer #7 (0.96mm) swap to Jade White
At layer #10 (1.2mm) swap to Red
At layer #16 (1.68mm) swap to Orange
At layer #19 (1.92mm) swap to Yellow for the rest.