Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Brown Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:
Start with Red
At layer #4 (0.72mm) swap to Orange
At layer #8 (1.04mm) swap to Black
At layer #15 (1.6mm) swap to Brown
At layer #19 (1.92mm) swap to Jade White for the rest.