KC Chiefs LED Lightbox
Copyright Claim
KC Chiefs LED Lightbox
Boost
56
127
47
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.6 h
2 plates
Boost
56
127
47
1
281
643
Released
Description
KC Chiefs Lightbox for the superfans!
Comment & Rating (47)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Looks fantastic! Printed on wham bam pex plate for a nice shiny finish.
The designer has replied
0
Reply
Awesome! Can you share a pic of the final results? I'm curious about how it looks on a Wham Bam
0
Reply
Replying to @MFDesigns3D
gives it a shiny store looking finish. I tried a carbon fiber engineered plate, it was meh. Textured PEI is good as well.
0
Reply
Replying to @nfntruth79
Real nice! All I have are textured and carbon fiber. I agree, the CF doesn't work very well. I'll have to look into a Wham Bam. Thanks for sharing!
0
Reply
Front view looks great. Printed on Wham Bam PEI plate. However, looking from the side I had some noticeable defects. I'd welcome any advice to reduce those. X1C, PLA, temps 220 and 60 C, Aux fan off. If you ever think about any changes, I would rather have the cord hole in the rear plate. You have many awesome projects. Thanks for sharing them.
The designer has replied
0
Reply
So the problem comes from the wham bam. For lightboxes the flow rate needs to be increased to ensure there aren't any pinholes, gaps, etc. Unfortunately the increased flow can cause ripples from over extrusion. The wham bam seems to make those ripples stand out even more than it would on a textured build plate. I bought 2 wham bam plates and never use them because of this issue.
0
Reply
For the cord hole, I solder the led strip to a USB-C module. Exiting out the side works best for that. But you can always add a hole in the backplate with Bambu Studio to suit your needs.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Turned out great. Printed for my boss
The designer has replied
0
Reply
looks great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Love it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
after a couple failed attempts due to issues on my end I finally got it to print without any issues. the model is fantastic and I’m very happy with the results.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed Amazing!
0
Reply
looks great!
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld