this one did not come out the best printed 7 other different ones the same day and this was the only one with first layer problems but other than that it was good
Sorry that happened to you. it's not an issue with the model or profile. Someone had a similar issue happen with another one of my models. after reviewing his timelapse it ended up being his cat lol. not saying that's what happened to you but I'm willing to bet if you clean the build plate and reprint it you'll see it prints great
The design is pretty good, although I World have liked a bigger opening for the cables. Maybe it was my fault for printing it too small. I did not scale it up.
Thank you for designing it
Hey, I used these lights https://a.co/d/9ZB2cpj with this controller https://a.co/d/3knlekv
But, I made this back when I first started making lightboxes. This was overkill and far too expensive. I know better now. If I were to do it again, I'd just go to any dollarstore and buy a strip of coloured lights. They sell full RGBW lights with a remote for $5CAD. Just make sure to use hot glue to stick it to the walls. The tape on the LEDs will eventually fail.