灵感来自碧蓝档案中的一张过场图片。
最初的一个原型是直接从这张图片上截取的;
https://www.bilibili.com/video/BV1hXgPeJE9U
不过这带来了无用的白边和模型上的锯齿、失真。
之后我在aseprite中为它重新绘制了像素画原型。
https://www.bilibili.com/video/BV13LgKeWEa7
实物图:
新的模型更精确,(虽然由于尺寸较小,在0.4喷嘴上会有轻微的表现不佳。)
我打印的时候使用的是0.4喷嘴;0.2喷嘴可能会有更好的表现。
模型提供了四种,从上到下分别是:
原模型;
冰箱贴(背后有一个3mm×1.5mm的孔安装磁铁。当然理论上扩扩孔说不定能给高达装上…);
开孔挂件(孔位在内侧,对图片内容有一点轻微的影响);
挂件(孔位在外侧,整体轮廓可能有点不好看)。
————
(*machine translation)
The inspiration comes from a cutscene image in the Blue Archive.
The initial prototype was directly taken from this image;
https://www.bilibili.com/video/BV1hXgPeJE9U
However, this brings useless white edges and jagged and distorted models.
Afterwards, I redrawn the pixel prototype for it in aseprime.
https://www.bilibili.com/video/BV13LgKeWEa7
The new model is more accurate, although there may be slight performance issues on the 0.4 nozzle due to its smaller size
I used a 0.4 nozzle when printing; 0.2 nozzles may have better performance.
The model provides four types, from top to bottom:
Original model;
Refrigerator sticker (there is a 3mm x 1.5mm hole on the back to install the magnet. Of course, theoretically, expanding the hole may be able to fit the Gundam...);
Open hole pendant (hole position on the inner side, slightly affecting the content of the picture);
Hanging piece (with holes on the outside, the overall contour may not look good).