Made with army green Overture PLA, this over-the-door hanger was made to hold anything you don't want on the floor from jackets to towels to hats. Helps declutter and organize a room. This model was made to be compact and printable on any printer. I used this one on recent travels and it worked great for drying out my rain jacket! Some doors are thicker than others so feel free to modify the width of the door part.

As for all my prints, I am using an Ender 3 Pro with a 0.4mm nozzle and upgraded boden tubing, springs, and a Creality glass print bed. I used Cura 5.4 software and the following settings to slice this model.

Print Settings:

• Layer Height: 0.2mm
• Nozzle Temperature: 215°C
• Bed Temperature: 55°C
• Initial Layer Speed: 30 mm/s
• Print Speed: 75 mm/s
• Retraction: Enabled
• Print Bed Adhesion: None
• Infill: 20%

Please reach out with questions and leave a comment down below if you try this out for yourself!