Hey folks, this is my first model. Your feedback is much appreciated!

Summary

For those who are familiar with HueForge you will mostly be interested into these information:

• This print uses 3 unique filaments: black, white and a color of your choice
• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
• You may print at higher layer heights below the Min Depth of 0.48mm.
• Swap Instructions:
  • Start with Black
  • At height 0.56mm swap to White
  • At height 1.04mm swap to Black
  • At height 1.12mm swap to Pink/Orange/Red e.g.
  • At height 1.92mm swap to White for the rest.

I added an extra height of 0.24mm to make it less floppy. Feel free to remove this height from the back to save some filament.

Additional information

To print this HueForge, no AMS is needed. Just slice it, navigate in the “Preview”-Tab to the desired layer and right-click on the slider. Now you can choose to either change the filament to a certain one or add a pause. When the 3D-printer has paused you can manually load the next filament.

Filaments used as seen in the pictures:

• Extrudr PLA NX2 black (low TD)
• Polymaker PolyTerra Cotton White (medium TD)
• Rosa3D PLA Starter Neon Orange (high TD)
• Devil Design PLA Emerald Green (high TD)
• Jayo Silk PLA+ Red Copper (low TD)

I used the stand of @PenolopyBulnick in the pictures: https://makerworld.com/en/models/153050#profileId-167215 (size: large)

If there are any questions left please feel free to ask.

And now: Happy printing!

Please share your prints and show me your favorite color of the Flamingo :)