Hashira Rengoku Sword multi part
Copyright Claim
Hashira Rengoku Sword multi part
Boost
12
11
5
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
37.6 h
6 plates
Open in Bambu Studio
Boost
12
11
5
0
16
1
Released
Description
Rengokus nichirin sword printed in pla at .16.
I have two bottom parts of the sword one where you can paint it yourself or ams.
Small 1/8 metal rods to join parts with glue to make more structural.
recommended petg for supports to get a smooth print on blade, but pla doesnt do bad either.
profile is set to pla supports.
Comment & Rating (5)
All
I don't know why the pictures are blurry
0
Reply
surprised you didn't steal their pictures too.
0
Reply
finally a rengoku katana I have been looking all over for one of these and I could not find one I will send a make when its done
0
Reply
Replying to @user_1320426353
wait this isn't his?
0
Reply
Dont like me calling you out huh buddy!! guess he doesn't like everyone knowing he didn't model this and has stolen parts and pieces from several models!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld