Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.

Swap Instructions:
Start with Blue
At layer #8 (0.72mm) swap to Ice Blue
At layer #13 (1.12mm) swap to Black
At layer #19 (1.6mm) swap to Blue Gray
At layer #20 (1.68mm) swap to Gray
At layer #22 (1.84mm) swap to Jade White for the rest.