Search models, users, collections, and posts
Magic potion
IP Report
Print Profile(2)
0.2mm layer, 4 walls, 0% infill
Designer
2.8 h
3 plates
New Version - 0.2mm layer, 4 walls, 0% infill
Designer
4.6 h
5 plates
Open in Bambu Studio
Boost
101
284
16
9
92
58
Released
Description
After everything is printed, the parts for the holder are only screwed together, not glued. The bottle sits loosely in the holder.
If you place the parts to be molded in hot water or on the hot print bed for a while, or carefully heat them with a hairdryer, they can be easily shaped without breaking. This was not necessary with my model, but this can vary from filament to filament, even if everything is made of PLA.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)