Do NOT adjust the size in your slicer!! The layers will not come out right.
Do not change the size, this will cause errors in color change compromising the entire print.
Use my print profile or you will not get the desired results.
It can be printed safely without AMS and on any printer.
I hope you like it, I hope you like it, if you want to support me leave a like and vote five stars thank you!
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 180x180mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2mm
Filaments Used:
PLA BambuLab Matte Nero Transmission Distance: 0.1
PLA BambuLab Matte Marrone chiaro Transmission Distance: 0.5
PLA BambuLab Matte Grigio Transmission Distance: 0.5
PLA BambuLab Matte Bianco Transmission Distance: 1.8
PLA BambuLab Matte Rosso Transmission Distance: 1.8
PLA BambuLab Matte Giallo Transmission Distance: 5.2
This print uses 6 unique filaments
Swap Instructions:
Start with Nero
At layer #7 (0.64mm) swap to Marrone chiaro
At layer #8 (0.72mm) swap to Grigio
At layer #10 (0.88mm) swap to Bianco
This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
At layer #14 (1.2mm) swap to Nero
This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
At layer #17 (1.44mm) swap to Bianco
This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
At layer #18 (1.52mm) swap to Rosso
This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.
At layer #21 (1.76mm) swap to Giallo for the rest.