Bambu X1 Rear Chamber Hygrometer Stand by Cruv1291

Cruv1291

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

24 min

1 plate

4.9(66)

0.2mm layer, 2 walls, 15% infill

22 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

124

224

196

Released

Description

So if you're like me you have a few hygrometers around that have the little tabs or clips on the side that seem to not work with everyone's nice hygrometer holders.

Mine are from Amazon over here and look like this below.

I liked a few of the ones already on MakerWorld, and even remixed one of the ones I liked the best over here. However those designs weren't as sturdy as what I was looking for and pointed the hygrometer at an angle I didn't find useful with the AMS on top.

So I made another with some changes to my own preferences!

Those changes are are:

1. Use as little material as possible.
2. Take up the least amount of room possible.
3. Have the hygrometer point at the camera for easier readability.

4. Avoid having the print get bashed by the tool head during hot end cleaning cycles.

All of these are accomplished with my model and it looks fantastic while being functional.

Let me know what you think and feel free to request changes you would like to see.

Comment & Rating (95)

@Zzazel

Print Profile

0.2mm layer, 2 walls, 15% infill

Amazing, great idea. Although the nubbles at the bottom don't print that well. Still works tho

The designer has replied

@Cruv1291

I think this is for a different model right? Those look like gears to me.

@Zzazel

Replying to @Cruv1291 :

look to the left😂

(Edited)

@Cruv1291

Replying to @Zzazel :

haha in my defense it was a really late night for me! glad it’s working for you 🤣

@fishercraigj

I've been fighting warping with ASA as the season has turned cold and my basement is cold enough to make my toes freezing all day long while I work in my office. That being said, I even have to throw a blanket over my printer to get it to where I need to be for ASA. The gauge, as simple as it seems, is probably one of the most valuable tools that I have especially since I cannot remove the blanket from my machines without risking a temperature drop.

The designer has replied

@Cruv1291

This comment has my simple designer ego at least 100x the size it was before I read it. Thank you!

@kiyotakeru

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect angle for the X1C camera to clearly read the display. Some others are tilted upwards that makes it too glarey to see.

The designer has replied

@Cruv1291

thanks for the review!

@ledvinaphotogra

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect fit in my P1s, love that it is angled towards the camera for a perfect shot of the hygrometer.

(Edited)

The designer has replied

@Cruv1291

glad it’s working out for you!

@OzDruiD

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed well @Cruv1291 - I went ahead and printed it , and the off-angle Hygrometer just snapped in with a bit of force, ignoring the cut-outs in your model. Printed in Bambu PLA Tough Grey, I have also included a screenshot with in in place with the other drop one. Yours has better visibility, I assume to the angle. Well done.

(Edited)