模型适用于六寸相片，透光浮雕画设置参数：宽度和高度为152mm、108mm，根据照片的长和宽设置，一次可放六张相片，模型预留很多孔位和过线槽，可在原模型上添加第二层、第三层，底部相框盒镂空，可加装风扇给led灯带散热

装配需要M3-12、M3-22内六角螺栓，M3-10平头螺丝，3-5-4.2或3-5-4.5热熔螺母，led灯带（建议12V，亮度3000-6000），适配电源线（需接线），薄壁轴承50-65-7（价格在8.5元左右，需要两个）

若没有支撑材料，3mf文件中支撑材料可用主体材料替代，需要支撑的地方不裸露，不影响外观

The model is suitable for six-inch photos, the translucent relief painting setting parameters: width and height of 152mm, 108mm, according to the length and width of the photo, six photos can be placed at a time, the model reserves a lot of holes and slots, you can add the second and third layers on the original model, the bottom photo frame box is hollowed out, and a fan can be installed to dissipate the heat of the LED light strip

Assembly requires M3-12, M3-22 hexagon socket bolts, M3-10 flat head screws, 3-5-4.2 or 3-5-4.5 hot melt nuts, LED strip light (12V recommended, brightness 3000-6000), adaptation power cord (wiring required), thin-walled bearing 50-65-7 (the price is about 8.5 yuan, two are needed)

If there is no support material, the support material in the 3MF file can be replaced by the main material, and the place that needs to be supported is not exposed and does not affect the appearance